hl foccers one and all, im having trouble with my tps i believe it to be focced the bikel seems to be running ok,
been looking online they all seem to be for the s sp n all bar just wondering if anyone knows where i can get a replacment and if it is still ok to ride.... fzs 600 fazer 03. noob here by the way
regards mogs :'(
I ordered a new coolant drain screw for my FZS1000 90163-06002 this seemed to supersede 90153-06029, it just does not look right though, looks far to big. But thats what fowlers says.
I have been having issues with the bike just not feeling like its got the power it should have....
It also seemed hard to start, always needs full choke and even after warming a little is easy to stall, unless its been ridden for a while and its red hot...
I have checked a few things, Carb Sync, all but one are spot on, cylinder 3 shows a little less reading than the rest, 20 less, so is an issue there.
I also took the chance to measure the cylinder compression and get from 1-4 readings of 110, 100, 115, 102, so varied and well off what the service manual states.
Will be trying to pop some oil in the cylinders tommorow or Monday see what a re-test shows.
Engine has done 47K, and i had to replace the Water Pump and rear wheel bearing when i got it, not well looked after...
I also changed all exhaust studs and replaced the cylinder head gasked whilst in there, replaced spark plugs also.
Anyone any comments, do these readings seem well out or reasonable for a bike of this mileage/age
Just wanted to say a massive thank you to everyone who helped me out with advice and offering of parts whilst me and my bike were recovering from our accident in January, massive thanks to Graham especially for the engine case as well.
Good news is the bike and I are now back on the road and she is as good as new, new fairing, new mirror's, new engine case, new oil and filter, new clutch, new cables and levers, and of course new exhaust (SP Engineering can sounds amazing by the way?).
Picture below of how my bike is looking now.
Really wanted to post this just to show my appreciation for this group, everyone on here has been really helpful and friendly and I just wanted to say thanks for it, especially through the tough last mouth.
After picking up my Fazer last Wednesday, todays been the first chance Ive had to start having a proper poke around it. So, after getting rid of some of the anodized blue bits fitted by a previous owner (on a gold bike? really?), I took the seat off to have a look underneath. No tool kit, but my tool roll fits in fine, with my disc lock and sidestand puck. Noticed its had a datatool evo alarm fitted, as the control box is still there and looks to be still connected, although I dont have the fobs for it. Theres also 2 mystery connectors under the seat, anyone know what theyre for?
