hi all
im looking for a 2 female to 1 male bullet connector.
i know i have seen these on fleabay, but for the life of me i can't find them now!  :o
if anyone can help me i'd be really grateful.
save me tearing out what little hair i have left!
thanks

Hi Has anyone experienced problems with operating this sat nav from the bike battery. Mine stopped working from the direct battery cable and will not charge. I have changed the cable to the battery and the bike dock to no avail. Any suggestions or solutions please. Regards Mike

Anyone use them?are they any good for protecting the front of the engine and radiator etc?

Finally nice & sunny, so I decided to take the bike out for a spin. (We don't have polar bears here, but three weeks ago you could still go skiing).

I had drained the float bowls in the autumn, and when I connected the battery and turned ignition on the fuel pump buzzed quite normally. The bike started ok with choke on, but after a few seconds started running kinda odd, wouldn't keep going except on throttle, and then I noticed I was standing in a fuel puddle.

Here's what I've found out so far:

- Fuel just oozes out of apparently from the front of the carbs, with no clear source of where it comes out.

- Tapping the float bowls didn't seem to help, tried that twice after draining the float bowls. I've had a stuck float once earlier, right after I put the Holeshot kit in, but that was easily rectified by tapping the bowls (thanks Mike!). But that time the excess fuel spewed out of a carb overflow hose.

- If I drain the float bowls and then switch ignition on but don't start the engine, after a while fuel starts to seep out of carbs 3&4 while 1&2 seem to remain dry. I don't know if waiting longer would start the leak also from 1&2.

The bike's got a Holeshot kit in, and at the same time I at least tried to adjust the float levels as per Pat's instructions. Apart from the first problems, it has run fine with the kit for 3,000 miles and one spring start before this.

Any ideas?

(God, how I hate pulling carbs... Any suggestions as to how to get especially the 2&3 airbox side rubber boots to seat easily on carbs are also welcome. Nearly drove me crazy the last time before I got them straightened and clamped.)

First test pic of  FZS 600

Attached Files

Thumbnail(s)
   

Mid wales,Brecon,Llandovery ,Rhayader,Merthyr


Anyone out and about on Bank holiday Monday, or coming through to Wales from Brum, Worcs,?


I fancy a trip over them mountains, Aber perhaps

So i managed to hold back the tears as the geezer loaded my bike onto the van to take it to the menders.It was emotional.Still my missus has almost got me convinced it will come back shiny and new and even better than before.If i knew how i would post a picture of the bruise on my leg just to give jason a laugh. The good news is your all safe for a while even the silver ones for now.keep it shiny side up folks

I have tried a search but , not great results as I got  lots but nearly all for either hid or for 600's

I need to replace mine and im just wondering what everyone is currently recomending
I dont much fancy doing a HID converstion !

Hi all, just thought that I would introduce my self to the forum.  My name is Phil, and have owned my FZ6 S2 for over six years.  I have had this bike from new and still love every minute on it.  It's a 07 reg and I have made one or two changes along the way, like new pipes, belly pan, seat cowl etc. Will try and post some pics of my bike later, when I get used to the forum. 


Many thanks
Phil. 

Hello all!

Has anyone got a spare tail tidy, or even the original piece of plastic that holds the number plate and indicators? Mine's a bit scruffy, and repairs haven't been hugely successful.

It's only a detail, but it irritates me. If you have one, please let me know!