Foccers i would like to replace my front wheel  guard any advice on where i can get one from much appreciated

Anyone got a standard screen available? Thanks.

Hello fellow foccers,

I am in need of a clutch actuator as the one on my bike is focced! (1998 fzs600)

Does anyone have one for sale? or point me in the direction of one please.

Ta very much xx

Hello fellow foccers,


I am in need of a clutch actuator as the one on my bike is focced!


Does anyone have one for sale? or point me in the direction of one please.


Ta very much xx

I have just learned from the FZS600 section that a 6 sided socket is less likely to round off a nut. Never knew that  :o I will be fitting a new chain and sprocket set and I have the sizes I need but they are all 12 points

So I am going to invest in a few for the  :faz rear wheel / sprocket nut/ and a 14 and 17mm. Are these Draper ones a waste of money https://www.toolstation.com/12-drive-6-p...et/p52746. If so any recommendations of something better.

Hi all, I need some help, I had a new front tyre fitted the other day on my fzs600, I've now done about 80 miles on it. Right from the off there has been a bearing type noise coming from front, and it's still there, is it possible that the front wheel bearings can now be defective as a result of a new tyre, or ... could it be a fitting mistake ie hub axle nut over tightened, I do not trust the company that did this work for me now ! Just want to get my bike done properly, any ideas would be very welcome thank you Alan

Genuine GYTR risers for FZS 1000


SOLD

For sale: 2001 Fazer 1000 in red.

Bike now on ebay

morning foccers , my cooling fan has stopped working, I've checked all the wiring connectors  associated with the cooling fan and all seem in good order and the fuses are ok ,has anyone had this issue in the past  ,my electrical knowledge is basic to say the least so any help would be appreciated ,

front end strip fairing, forks, yokes speedo off, connector blocks under left infill disconnected and tank off.


Put it back together and mot'd,  however, the speedo isn't working.  The rev counter is working.


There is just the one plug in to the clock cluster?  I can't see any other leads unaccounted for.


Any ideas what the problem could be, apart from me of course