Anyone having a flutter today?


What's your choice?

Hi guys,


The Carronvalley MCC are doing their Easter charity run again this year in the 16th April with all monies going to CHAS, meet at the bottom car park near the Wheelhouse Restaurant for 10am with ride leaving 10:30 sharp.


I'll be there with Disky


https://www.facebook.com/events/253928128386595/

I've noticed of late that there appears to be a rattle when in neutral.  Disappears when I pull in the clutch but is there when released.  Also, sounds a bit like I have a nest of starlings in the gearbox when moving/accelerating!

Any idea's fellow Foccers?

I went out for a ride today and on the way home the speedo needle started waving around randomly, only slightly to begin with but by the time I got back it was thrashing about all over the place. When I checked it, the cable had been rubbing on the disc and had worn through to expose a tiny patch of wire that was shorting out on the disc, so I've rerouted it and I'm going to have to sort it properly tomorrow. I'll wrap some insulating tape round it for the time being but has anyone got any ideas for a more permanent repair without replacing the cable?

Hi all,  to those of you that have fitted after market end cans, which cans allow the center stand to be retained. Cheers.

Recently bought an x reg boxeyed fazer 21k miles nice condition was gonna book mot until i checked the lights--when i switch on side lights the n/s bulb is on and the o/s has a little bulb lit up but main bulb is out when i switch to main beam the o/s lamp is lit up i changed the o/s bulb but still the same result --am a bit puzzled by this or is this just peculiar to this bike--woah just read that back now am really confused--if anyone can cast any light on the subject(no pun intended)it would be appreciated-stu

Any of you crazy Foccer's out Sunday 9th ?
Me and my brother are going to hit the twisty stuff to Headcorn aerodrome to Rye hitting the Camber curves.
Weathers looking great, meeting at mine, just throwing it out there in case anyone fancys joining us.

Evening

Much to my chagrin, I only just discovered that the bloody rear hose has been rubbing on the rear wheel and needs replacing asap.

Does any one have a stock rear hose or a black covered braised hose.

many thanks

b.

please delete.

2002 fzs 600


I came to change my rear pads, after the brake had been getting progressively worse. Ive noticed that the pistons are pretty far out and have a lot of corrosion around the rim. Ive taken ther calliper off, split it, got it in the vice but it wont budge with anything i can get on it, short of welding somthing to it.
I gave up for the day, and decided to look for a used caliper.
theres only 1 that i can find on ebay, its £90 and its in spain.......

so, i may have to put new pistons in this, but as the pistons are corroded-theres traces of corroded rubber, presumably a seal where it come out too far, i'm worried that bthe bore may be knackered too.

Is there any other callipers that people have used on the rear, as these seem pretty scarce, and expensive for what they are......

if not, has anybody had any dealings with re doing the pistons? ive seen stainless ones on wemoto, but its going to be about £70 for those......

An expensive day, as i probably need to replace the disc as well.....


Thanks in advance for your help