Hi All, has anyone got any carb rubbers they no longer need?  Preferably new.  Cheers

Hi All,

Has anyone on here purchased those cheap carb rubbers off Ebay?  If so, how did you get on, are they worth the money or is it best to just swallow £70 for ones from Fowlers etc?


Cheers

MY03 200miles of 55k.

Replaced the headers probably 8-9 years ago cannot remember with what but they are SS and looking ok for thier age.

But this week i started to notice at startup an odd noise at idle. I stop at a set of lights 1/2 mile from home every weekday and by then the noise disappears until the last few days.

So it's definatly turned into blowing headers.
The nuts are SS and holding up to the year round weather that is thrown at them but this is the big but

the studs (90116-06475)

look like they have rotted with corrosion can this happen to a 55k 16year old bike.

Will I need to replace the studs with new one's which i know can be a knightmare.

may try and put a photo on tomorrow.....

Hi guys,
browsing the internet for quite a while now, i couldn't find any appropriate info about R1 forks swap from these particular year, 2002-2003. 99.9% info is about swaps taking 2004 and later years R1 forks.
Have anyone tried fitting 2002-2003 R1 forks to FZ1? What parts required, etc.
2004 and above option is not available for me.
Thanks!

AGV K3 any good?

Any other recommendations?

So I noticed today that my brake light was constantly on. Gave a wiggle to the rear brake switch and out it went, thought I would fix it later as late for work.
Got to work and it was permanently on again so gave the mount a wiggle again and it didn't go out. Sprayed a load of WD40 as I  thought it might be sticking and pulled the rubber boot off and sprayed load in there as well. Thats when the smoke appeared!! Disconnected it for the return home.
So does it just need a good clean, the clips look reasonable, or should I just replace it? The plunger moves fine with the pedal, but if it smoking is something shorting


Also if I wanted to change the piston seals on the rear calliper, do I need to split the calliper itself, or can it be done whole?


Cheers
Nick

Started it at the end of March, just got to find a nice old table and a sofa. Chuffed with it.

Hi All, just dipping my toe in the water to see what is about.


Is anyone selling am FZS 600 Fox eye?  Preferably red, or yellow.  Blue owners need not reply, I couldn't stand the ribbing off the LOFOs  :rollin 


I should add, I'm in Kent, I'm willing to travel a bit but places like Scotland and Cornwall could be too far  :b


Cheers in advance.


Harry

I think I read on here some time ago that some one had found a plastic plumbing pipe glue that worked on fairings and other bike plastics but I can't find the post does any one remember what it was called.

Well finally got my new bike this morning.

Attached Files

  54A3F9C3-21BD-4CA0-8E2B-7EE26AB3EC1E.jpeg (Size: 96.45 KB / Downloads: 106)
  3D84D38F-0B42-4B9B-98C0-26EC50161796.jpeg (Size: 96.45 KB / Downloads: 99)