Any of you fine chaps out there found an easy, cheap way to remove rust from bolt heads, footrest, brackets etc?  My 600's looking a bit sad in a few places from the daily commute!  :'(

Has anyone tried these?

http://www.ebay.co.uk/itm/FZS-1000-FZS10...1e6c52a6f8

Cheers

John

If I posted the .. just the top line of the registration numbers of my three (mint) Gen 1s and requested that the current owners contacted me I might discover where they are now? 

It's a good bet that at least one of you guys (if not three) in here will have one of them  :b

No special reason .. just wondering where they are now .. as you do  :\ .

Stay Safe    Polar Bear

On Monday I will finally be doing my mod1 test and if all goes well mod2 on Friday. Just wondering if anyone has any advice? I've got training on Sunday but any extra advice would be much appreciated

http://www.ebay.co.uk/itm/Yamaha-FZS-FAZ...3373d2ed8a

£2000 ono px thunderace/fzs thou or a VFR  :evil

2002 seat has rips good for recover or padding upgrade  used it whilst mine was off being recovered

bewizz has first option at the mo

£60 posted

yam gen 1 belly pan

all correct with all fittings has had a repair done to a crack q bonded internally
external stone marks as usual crack covered with a sticker

good condition otherwise use as is or repaint

£70 posted uk

I'm going to fit some LED indicators to my FZS600, they're rated at 2 watt each.

What rating resistor do I need?
Do I need a resistor for each indicator or can I run both indicators a single resistor?

Hi guys I'm new here an I'm new to the fazer to iv owned it since November last year and it's all going well so far iv had the cam chain tensioner replaced as iv found that this is a comman fault this has made a huge difference to the noisy engine that it was lol I had the carbs balance at the same time which was also needed, but my question is this, I recently put a un baffled beowolf can on the bike (which sounds great) but iv found out that the popping/burbling it does now on deceleration could mean its running lean? It's got also a hiflow air filter and oil filter, but was thinking about the individual k n n filters, anyway iv herd conflicting things about this running lean situation so I was going to get the bike rolling roaded and basically was wondering if they would be able to diagnose it from this and give me info on what I can do as iv herd it's bad for the engine, I'm new to tuning bikes but wanna get stuck in, any advise would be awesom cheers

Anyone know where i can get a radiator for my gen 1? I've looked on fleabay and the only one I saw was broken! Seem to have sprung a leak, slap bang in the middle where the rubber grommet sits, might try radweld as if it is leaking, its only a small one!