Reg Rec Wiring

[Slippy]

Hello!

The reg/rec on my fzs 600 2003 has melted the connectors! It also has been rewired so a standard oem rec/reg wont fit any more.

Few questions!

1. Does the order of the white wires matter when connecting to the reg/rec ?
   
2. Could i just hard wire it with my new reg/rec ?
   
3. If no on number 2, what connector do i need and any advice / tutorial on how to fit the wires into the connector ?
   

Thanks all!

[agricola]

1) No
2) Yes, but good, clean soldered joints, well insulated from each other.
3) If you are buying a new RR, I believe that you can unclip the spades from the connector plug and purchase a replacement male and female connector for both ends. I have used this company before https://www.vehiclewiringproducts.co.uk/

[unfazed]

45a Anderson Power Poles are the best solution and is what I used back in 2017. Neat finish and can be disconnected easier than the original was before burning out

[midden]

45a Anderson Power Poles are the best solution and is what I used back in 2017. Neat finish and can be disconnected easier than the original was before burning out

How often do you need to disconnect it?

[Slippy]

Thanks for the replies!


I’m just going to hard wire it, been advised by a mechanic friend that crimping it would be the best solution so will do that.


Can’t be bothered with adding new connections to faffy and could melt again!


Thanks all

[unfazed]

[quote author=unfazed link=topic=27514.msg330369#msg330369 date=1664547366]
45a Anderson Power Poles are the best solution and is what I used back in 2017. Neat finish and can be disconnected easier than the original was before burning out

How often do you need to disconnect it?
[/quote]
You would only need to have to do it once