Speedo Cable shorting - revised!

[pezos]

[color=rgb(0, 0, 0)]Hello,[/color]

[color=rgb(0, 0, 0)]So looks like my speedo cable has been routed incorrectly and I found it being sliced in half by one of the front discs. Does anyone know it the cable is its own part that I can replace or does it belong to the (expensive) sensor assembly?[/color]

[color=rgb(0, 0, 0)]2002 FZS600[/color]

[color=rgb(0, 0, 0)]Many thanks....[/color]

[unfazed]

Sensor is all one piece including the cable. Should be a few on ebay

[vinnyb]

Can you not cut and splice it at the break?

[Disorderlypunk]

if its half way up your in luck- time to get out the soldering iron and some heat shrink

[Jules-C]

Been meaning to replace my temporary insulating tape repair with a permanent heat shrink solution but the tape lasted about 10 years now

[pezos]

Hi all


Sorry for the delay... been struggling to log in (goggle chrome - using bing now)!


Thanks for the replies, does anyone happen to know how many wires are inside the speedo cable if I do need to solder them? Ideally an aftermarket replacement if anyone know where I might find one?


Thanks again, much appreciated.

[Disorderlypunk]

i i remember correctly there are three

[pezos]

thanks a lot disorderly punk