24-01-19, 07:09 PM
What are the two bolts on the opposite side of the exhaust from the EXUP cover-plate for?
They are located behind where the internal bush of the EXUP valve is situated.
![[Image: 9dc86351e03d82faa9d37a286c07a896.jpg]](http://uploads.tapatalk-cdn.com/20160407/9dc86351e03d82faa9d37a286c07a896.jpg)
Thanks
Simon.
|
EXUP Question
|
 What are the two bolts on the opposite side of the exhaust from the EXUP cover-plate for? They are located behind where the internal bush of the EXUP valve is situated. Thanks Simon. 
25-01-19, 07:27 AM
More importantly, you seem to have dripped black paint on your exhaust!!
25-01-19, 09:02 PM
Daft as it sounds, the bolts are to hold the cover plate and that's all.
25-01-19, 09:12 PM
Ever wondered why your post got 109 views before any input?.
Whizz kid sitting pretty on his two wheeled stallion.
25-01-19, 10:06 PM
I must say I thought these cap screws were simply blanking off two access points so that you could put a pin punch in there to drift out the bush supporting the end of the valve if it needed replaced. I did not think there was a blanking plate on there.
If at first you don't succeed, pull your foreskin ower yer heid!
26-01-19, 06:24 PM
(25-01-19, 10:06 PM)Decoke Dave link Wrote: I must say I thought these cap screws were simply blanking off two access points so that you could put a pin punch in there to drift out the bush supporting the end of the valve if it needed replaced. I did not think there was a blanking plate on there. I think you're right. I've never removed them on my bike so assumed that it was a cover plate, too. Access to drift out the inner bush makes perfect sense.
|
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)