Red Rubber Grease & Copper grease

[Dave48]

For anyone contemplating brake service/overhaul I can supply 20gm tins of these.
Red Rubber Grease OR copper grease (1 tin) cost £2 posted
Both products 2 tins)  £3 posted
Paypal preferred. PM me if interested.

[Dave48]

Still have a few tins of  the above if anyone wants?

[Andy Clap]

For anyone contemplating brake service/overhaul I can supply 20gm tins of these.
Red Rubber Grease OR copper grease (1 tin) cost £2 posted
Both products 2 tins)  £3 posted
Paypal preferred. PM me if interested.

Where is the red rubber grease used Dave?
What's used for the swingarm pivot?

[JoeRock]

Red rubber grease is used for the brake pistons mate. YOu could use it for the swingarm but its a bit pointless - normal lithium grease is whats normally used on bearings as its good and cheap!

[Dave48]

Red rubber grease is used for the brake pistons mate. YOu could use it for the swingarm but its a bit pointless - normal lithium grease is whats normally used on bearings as its good and cheap!

As Joe says,Andy.
A light smear of redrubbergrease on the outside of the brake caliper pistons,helps keep out the water & s**t that eventually leads to seizing/sticking brake pistons, also helps piston/rubber seal interface.
Copper grease on back of brake pads(sparingly) and on any fastener that might be liable to corrode /seize-again only v. little needed.
Steering bearings, swing arm & rear suspension pivots-Lithium based grease as per Yamaha manual.

[wheelywill]

Hi i will take a tin of each if you have any left Cheers Dave

[Dave48]

Hi i will take a tin of each if you have any left Cheers Dave

PM sent, Dave48