Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FZS 600 misfire on 2 and 3 cylinder
#9
So compression look like this: 
1-155 psi
2-157 psi
3-158 psi
4-171 psi 
But there's some new stuff. While revving up at first got fire from the exhaust (looks cool but it never happened before) and after a bit of it engine started to work like clean, like it should. Took it for a spin,after up to 10 min it started worsening and died out. But fired up again so I went for a bigger circle around. After some time got worse and died. Barely started and quickly died again. Pushed halfway to my garage (luckily I wasn't far at the point the battery went out) but got too tired so went for another bike,jumpstarted and got back. 
Sparkplug 3 doesn't look wet like it was getting to much fuel but I've seen it wet before so I suppose it gets some.
After a few minutes when I was writing this fired right up
What in the hell is going on...
Reply


Messages In This Thread
RE: FZS 600 misfire on 2 and 3 cylinder - by Bikelife - 26-10-24, 03:57 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)