Fazer gen 1 float needle seat o ring
|
Fazer gen 1 float needle seat o ring
|
09-09-20, 03:59 PM
Measure the inside diameter, and the cross section, then look on e bay for that size “o” ring. You may have to buy 10, that’s more than you need but far cheaper than carb kits. Look out for ethanol resistant material.
I have done it this way on a cbr600 and a bandit 1200 pilot jets in the past. Hope this helps. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fazer gen 1 float needle seat o ring - by Johnrambo20 - 09-09-20, 10:59 AM
Re: Fazer gen 1 float needle seat o ring - by b1k3rdude - 09-09-20, 01:34 PM
Re: Fazer gen 1 float needle seat o ring - by FILZ6 - 09-09-20, 03:59 PM
Re: Fazer gen 1 float needle seat o ring - by Johnrambo20 - 09-09-20, 04:42 PM
Re: Fazer gen 1 float needle seat o ring - by Trebus - 09-09-20, 07:49 PM
Re: Fazer gen 1 float needle seat o ring - by Johnrambo20 - 09-09-20, 08:06 PM
Re: Fazer gen 1 float needle seat o ring - by ArchDruid - 09-09-20, 11:04 PM
|
