Renthall 758 ultra low bars
|
Renthall 758 ultra low bars
|
02-07-20, 08:54 AM
All my whitworth stuff and AF for that matter, have been confined to a metal box under my workbench, no doubt never to see the light of day again. All I know is the thread required is 16mm at 16tpi. If you remove a bar end weight, you'll need an allen key for that, you'll be able to measure the thread and see what's required.
Whizz kid sitting pretty on his two wheeled stallion.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Renthall 758 ultra low bars - by steve65 - 01-07-20, 04:28 PM
Re: Renthall 758 ultra low bars - by robbo - 01-07-20, 05:10 PM
Re: Renthall 758 ultra low bars - by PieEater - 01-07-20, 05:18 PM
Re: Renthall 758 ultra low bars - by steve65 - 01-07-20, 10:19 PM
Re: Renthall 758 ultra low bars - by robbo - 01-07-20, 10:54 PM
Re: Renthall 758 ultra low bars - by steve65 - 02-07-20, 06:11 AM
Re: Renthall 758 ultra low bars - by steve65 - 02-07-20, 07:39 AM
Re: Renthall 758 ultra low bars - by robbo - 02-07-20, 08:54 AM
Re: Renthall 758 ultra low bars - by steve65 - 02-07-20, 09:42 AM
Re: Renthall 758 ultra low bars - by teecee90 - 02-07-20, 02:33 PM
Re: Renthall 758 ultra low bars - by steve65 - 04-07-20, 04:53 PM
RE: Renthall 758 ultra low bars - by fazerscotty - 16-07-24, 01:29 PM
|
