07-04-20, 09:28 PM
(07-04-20, 08:25 PM)fazersharp link Wrote: Your vid was very useful. It looks like the bolts are too tight but I cannot remember if it is even possible to overtighten them, which then makes me think - is the stand twisted, it seems to have a sticking point at a place where there should be maximum pull by the springs at about the 8 oclock positionI did them at about 30Nm, is it safer to have them looser? There's maximum extension of the springs at that point, but it's like going over a circle so the component of the force that moves the stand is least.
I think I should get it off and clean it up a bit better in there too.