31-03-20, 05:05 PM
(31-03-20, 04:46 PM)red98 link Wrote: haven`t got a seal to measure but i can measure the the caliper body which should be good enough,give me a minute...
You need to allow for the crush effect, it's not much but must be allowed for say .05 - 1mm O/D. I've not got one to measure here but it should sit slightly proud no more than a mm.
One of the cheaper ones will work no doubt, it's not like it moves but I've never used anything other than what I've stated. I would go for non split rebuild first, if you can't get the pistons out then go for a split, it's takes only an hour ish to rebuild the thing.
Later