25-10-19, 08:41 AM
Extending the bit by a few mils does alter the angle of the cut and that's fine. Too far, though, and the bit becomes more likely to snap. This is not a good thing ...
You're doing great so far. Have you found the online guides to doing the installation? Which kit are you fitting?
With 2 holes enlarged per carb, I suggest you turn the mixture screws out by 4 turns initially. This isn't what you find recommended elsewhere but it's what I found worked best over time.
You're doing great so far. Have you found the online guides to doing the installation? Which kit are you fitting?
With 2 holes enlarged per carb, I suggest you turn the mixture screws out by 4 turns initially. This isn't what you find recommended elsewhere but it's what I found worked best over time.