24-10-19, 05:37 PM
(This post was last modified: 24-10-19, 05:39 PM by Falcon 269.)
Look OK to me but try this ...
Take the drill bit out of the vise, reverse it and try putting the non-fluted end into the hole to check clearance and depth.
You might want to run the drill through again very lightly just to clean up the edges. They look a little rough but it might just be the hi-res photo.
Don't worry about the vise touching the throttle plate, that's normal. You've actually achieved a steep angle of attack than I used to which might account for the different feeling you got on completing the enlargement.
Take the drill bit out of the vise, reverse it and try putting the non-fluted end into the hole to check clearance and depth.
You might want to run the drill through again very lightly just to clean up the edges. They look a little rough but it might just be the hi-res photo.
Don't worry about the vise touching the throttle plate, that's normal. You've actually achieved a steep angle of attack than I used to which might account for the different feeling you got on completing the enlargement.