24-10-19, 03:47 PM
As I’m comfortable that Ive sorted the problems with the cold starting Ive made the (rash) decision to fit Ivans kit.
Using a pin drill I’ve drilled the two air bypass holes but never felt the bit where it tightened up or dropped by 1mm. I used the drill using very little downward pressure as advised but it just seemed to keep going forever. Probably didn’t but it sure felt like it.
It got to the point where I was concerned I was over drilling so I stopped and took some photo’s. Do the holes look OK?
I also wondered if my pin drill was too fat as the chuck part touches the carb flap. Could that be upsetting the angle of attack?
Using a pin drill I’ve drilled the two air bypass holes but never felt the bit where it tightened up or dropped by 1mm. I used the drill using very little downward pressure as advised but it just seemed to keep going forever. Probably didn’t but it sure felt like it.
It got to the point where I was concerned I was over drilling so I stopped and took some photo’s. Do the holes look OK?
I also wondered if my pin drill was too fat as the chuck part touches the carb flap. Could that be upsetting the angle of attack?