23-10-19, 07:12 PM
Just had a close look at the “cleaned” jets.
They all look good through my new favourite toy, an illuminated magnifying glass.
One thing I did notice was that one of the main jet looks like a 130 whilst the others were 132.5.
(That would be replaced during the Ivan install so not too worried about that).
The reason for the post is that I’m changing the rubbers in the needle seat, but can’t actually get it out.
It wobbles when I grab with my fingernails but the rubber seal seems to be holding it in place.
What’s the best way to get it out?
Could use some long nosed pliers and a cloth but thought I’d check with you guys first.
They all look good through my new favourite toy, an illuminated magnifying glass.
One thing I did notice was that one of the main jet looks like a 130 whilst the others were 132.5.
(That would be replaced during the Ivan install so not too worried about that).
The reason for the post is that I’m changing the rubbers in the needle seat, but can’t actually get it out.
It wobbles when I grab with my fingernails but the rubber seal seems to be holding it in place.
What’s the best way to get it out?
Could use some long nosed pliers and a cloth but thought I’d check with you guys first.