(19-07-19, 09:27 PM)coffee link Wrote: [quote author=tex link=topic=25459.msg300721#msg300721 date=1563532236]Does this only apply to Gen 1only,because when I bought my Gen 2 the exup had been disconnected and the cables were underneath the seat,I have a Scorpion pipe and it runs through the rev range ok,with a bit of a snatchy throttle at low revs and popping on the overrun,apart from that it seems ok.I would like to lose that snatchy throttle but figured it was because it's fuel injection and not carbs which always seem nicer on low speed pick up,does anyone think a Power commander would help?
If you brought it from the dealers I would tell them to fix the exup properly, putting a eliminator on doesn't fix the problem, the bike won't run correctly with the exup open at low revs
[/quote]
The valve on the Gen2 is for noise / emissions purposes only and unlike the Gen1 has no effect on the bikes performance or power delivery. Again unlike the Gen1 the valve on the Gen2 is located in the OEM end can (not in the downpipes) so fitting any aftermarket can such as your Scorpion will necessitate having the cables disconnected and left in a convenient location like under the seat. So no the advice for a Gen1 EXUP valve does not apply to the Gen2.