11-05-19, 05:43 PM
I’ve got a 2003 fazer600 tickover is a bit lumpy, it seems that it’s running on 3 with no 3 exhaust pipe not getting hot as quickly as the others, ignition wise all is ok, new plugs fitted all sparking
So got my carbtune all set up, and what I found is that no 3 didn’t move off minimum setting with the other 3 at various settings.
I managed to balance 1&2, then went to do 3&4 but again I couldn’t get no 3 to alter, I then set the other 3 to no 3 to try and get it to run smoothly
I’m wondering if the pilot screw is not set properly, but where are they? The manual shows a view, but it’s a joint manual with the thundercat, and it of course shows the cat carb not the fzs one
Anyone got a pic of where the pilot screws are?
TIA
So got my carbtune all set up, and what I found is that no 3 didn’t move off minimum setting with the other 3 at various settings.
I managed to balance 1&2, then went to do 3&4 but again I couldn’t get no 3 to alter, I then set the other 3 to no 3 to try and get it to run smoothly
I’m wondering if the pilot screw is not set properly, but where are they? The manual shows a view, but it’s a joint manual with the thundercat, and it of course shows the cat carb not the fzs one
Anyone got a pic of where the pilot screws are?
TIA