24-03-19, 10:57 PM
(This post was last modified: 24-03-19, 11:05 PM by His Dudeness.)
You can spin up the chain on the center stand and wipe away any fling when the wheel is stopped and the engine is off (safety notice :lol ). If you put it on sparingly and don't over do it there isn't much fling. The manual even recommends using engine oil or a suitable o ring safe lubricant
LUBRICATING THE DRIVE CHAINThe drive chain consists of many interacting parts. If the drive chain is not maintained properly, it will wear out rapidly. Therefore, the drive chain should be serviced, especially when the motorcycle is used in dusty areas. This motorcycle has a drive chain with small rubber O-rings between each side plate. Steam cleaning, high-pressure washing, certain solvents, and the use of a coarse brush can damage these O-rings. Therefore, use only kerosine to clean the drive chain. Wipe the drive chain dry and thoroughly lubricate it with engine oil or chain lubricant that is suitable for O-ring chains. Do not use any other lubricants on the drive chain since they may contain solvents that could damage the O-rings. Recommended lubricant Engine oil or chain lubricant suitable for O-ring chains
LUBRICATING THE DRIVE CHAINThe drive chain consists of many interacting parts. If the drive chain is not maintained properly, it will wear out rapidly. Therefore, the drive chain should be serviced, especially when the motorcycle is used in dusty areas. This motorcycle has a drive chain with small rubber O-rings between each side plate. Steam cleaning, high-pressure washing, certain solvents, and the use of a coarse brush can damage these O-rings. Therefore, use only kerosine to clean the drive chain. Wipe the drive chain dry and thoroughly lubricate it with engine oil or chain lubricant that is suitable for O-ring chains. Do not use any other lubricants on the drive chain since they may contain solvents that could damage the O-rings. Recommended lubricant Engine oil or chain lubricant suitable for O-ring chains