Fitting Spotlights

[Frosties]

The one wire I cut into was soldered. and then wrapped in heat shrink. 


All other connections were made using insulated bullet connectors which were then wrapped in heat shrink.  I then wrapped the lot in electrical tape so there are no connectors exposed.  It'll be a nightmare to unpick should anything fail.


As for the issue of potential damage with the spots mounted on the rad.......I've no immediate plans to lay my bike down on it's side.

Nowt wrong with the electrical wiring fella - nice job.


Spots look good and I'm sure you notice the difference on the road AND the way others drivers react/see you. Same as me with the rad mount - least of my worries if the bike goes down.