16-08-17, 04:57 PM
(15-08-17, 08:19 PM)characticus link Wrote: Are the disconnected alarm wires at the standard alarm connector? If so there are two pairs that have to be connected (looped). These would be cut and fed into an alarm. One pair inhibits the ignition circuit, the other inhibits the starter circuit. I'd check those first. If those are ok then its onto the relay/diode assembly behind left side panel.
There is one wire with writing that says ignition, left cut. None of the wires are looped. Will have to remove tape on others to read. Was going to do it today but had family problem to sort out so no time.
Wires are nearside behind cross member. Battery > cross member > battery > wiresÂ