Gen 2 adjustable dogbone
|
Gen 2 adjustable dogbone
|
16-11-16, 11:05 PM
After fitting an R1 shock I had to lower the ride height (R1 shock is about 1" longer than the FZ1 shock). I checked fleabay and decided I could make an adjustable linkage myself so I bought a right & left handed M12 rod end bearing and a length of 19mm stainless hex and this is the result. Total cost £12.50!
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Gen 2 adjustable dogbone - by Rob R - 16-11-16, 11:05 PM
Re: Gen 2 adjustable dogbone - by devilsyam - 17-11-16, 12:00 AM
Re: Gen 2 adjustable dogbone - by Andy W - 17-11-16, 08:09 PM
Re: Gen 2 adjustable dogbone - by Rob R - 17-11-16, 09:39 PM
Re: Gen 2 adjustable dogbone - by Bubbaad - 19-11-16, 11:40 AM
Re: Gen 2 adjustable dogbone - by devilsyam - 19-11-16, 03:45 PM
Re: Gen 2 adjustable dogbone - by Rob R - 20-11-16, 09:35 PM
|
