CARBURETTOR Problems In Low RPMs

[darrsi]

On my bike I had carb problems blocked green/brown crust after cleaning them still not starting or firing ?
Found out O rings knakerd thus flooding tried a 2nd set that was on donor bike it ran but not brilliant but it ran,so I took them apart but not the best condition the screws only just came out of the float bowls ! so as my originals are clean I swapped the seats & O rings.


Bike started ran but died after warming up ? I realised too rich pilot screws set at OEM so two & three quarters of a turn out it runs ok now don't need choke to start either bike has a K & N filter.
I still get a slight hesitation around 2000rpm otherwise it pulls like a train I'm considering a dyno jet kit

They don't need a dyno jet kit.
Been there, done that, had to change back to OEM for it to run right again.