20-09-16, 09:34 PM
If you turn the ignition off with the kill switch, it will reset to the default position, (this is the time to check its position)
If your turn it off with the ignition switch it will not reset until you turn it back on.
A common mistake is to turn the engine off with the key and try to reset the exup.
When you are setting the exup.
1. Turn the ignition on (do not start the engine) wait 5 to 10 secs, turn it off again.
2. Not set your EXUP.
3. When you think you have it set correctly, start the bike, let it tick over, turn it off with the kill switch, you will hear the servo whirring under the tank and now check the setting again.
If it is not correct turn off the ignition and readjust it and go back to 3 again
If your turn it off with the ignition switch it will not reset until you turn it back on.
A common mistake is to turn the engine off with the key and try to reset the exup.
When you are setting the exup.
1. Turn the ignition on (do not start the engine) wait 5 to 10 secs, turn it off again.
2. Not set your EXUP.
3. When you think you have it set correctly, start the bike, let it tick over, turn it off with the kill switch, you will hear the servo whirring under the tank and now check the setting again.
If it is not correct turn off the ignition and readjust it and go back to 3 again