20-09-16, 05:45 PM
Just checked the EXUP valve, the cables where completely lose, the vale was not moving at all.Using Pat page as a guide I have tried to tighten the cables but when set at about 1.5 mm of play I get the 7000rpm fault code, so I loosen the cables and I can not get the fork shape to line up with the hole, it is close ,the fork is just before the hole. How close can you get to lining it up?
All so when you turn the bike off, the fork is at 10 o'clock and the hole is at 9 o'clock is this right, and when I rev the bike the valve does not seem to move much.
All so when you turn the bike off, the fork is at 10 o'clock and the hole is at 9 o'clock is this right, and when I rev the bike the valve does not seem to move much.