Skipping or spinning...

[anutz]

Soak circlip in wd40 they can stick/rust in and be a pain to get out. If really bad you can heat up centre with a small blow torch they then fold in half and come out, but you will need new after.
I know its more expense but its worth replacing both bearings while your at it, they have all done the same mileage and its job done for a good few years.

good luck

Des

I have a set on the way with 3 bearings i.e. 2 for the wheel and one for the sprocket carrier, as well as seals...


I shall read up on the other 2, the one i think may be tricky is the inner rear wheel one behind the sprocket carrier, i can see how to get the one by the disc, the one that is certainly knackered, and the one in the sprocket carrier is not hard, its the spindled one that i am trying to figure out...