Skipping or spinning...

[Fazerjon]

So i suspect i will be doing the following


New Front/Rear sprocket/chain
New Rear Bearings


The chain and sprockets i can change myself i have done that before


have never messed with drifting bearings out and seating new ones, is this best left to the local mechanics?


don't want to nacker the wheel

If you're replacing the wheel bearings while its all out, take your time drifting the old bearings out, try and drift it out evenly all the way round. Once the first one is out its much easier to access the next one. When you put the new ones in, I always use the old bearing on top of the new one to tap it virtually all the way home, just make sure you don't tap the new one in too far so you can't get it back out! Good luck.