04-07-16, 06:04 PM
I've been trying to take my torque arm off so I can fit my bluespot rear brake caliper on (and paint the rusted torque arm), but both of the bolts holding the torque arm seem to be seized to extreme.
I've been trying to loosen them up with RP-90 and WD-40, tried heating the bolts up with a blow torch and preceding to smack them with a hammer, but they just won't budge.
I then got out my bolt extractor kit, drilled half way through the bolt, put the left-hand threaded extractor in which is now stuck in the bolt too.
Does anyone have any ideas on how to get them off? I do have a welder but did not want to do that today, and can't think of what I could weld on to be able to get a good grip on the bolt.
I've been trying to loosen them up with RP-90 and WD-40, tried heating the bolts up with a blow torch and preceding to smack them with a hammer, but they just won't budge.
I then got out my bolt extractor kit, drilled half way through the bolt, put the left-hand threaded extractor in which is now stuck in the bolt too.
Does anyone have any ideas on how to get them off? I do have a welder but did not want to do that today, and can't think of what I could weld on to be able to get a good grip on the bolt.