06-12-15, 01:22 AM
(This post was last modified: 06-12-15, 01:23 AM by NorthWestern.)
Well, missus out and I found some foam board while clearing the garage out after replacing my front discs...
Started to make a pattern for some winglets/side panels that I am tentatively planning on making from carbon fiber at some point...
Just trying to get a basic shape really but here is the fruits of an hours labour while ducking in the house to check on the little 'un.
![[Image: 23548553405_26329414b9_z.jpg]](https://farm6.staticflickr.com/5690/23548553405_26329414b9_z.jpg)
![[Image: 23548564005_1bbc21ae6e_z.jpg]](https://farm1.staticflickr.com/577/23548564005_1bbc21ae6e_z.jpg)
![[Image: 22921486243_0b52fac9e5_z.jpg]](https://farm6.staticflickr.com/5774/22921486243_0b52fac9e5_z.jpg)
I am liking the shape so far, I wasn't after totally flat wings, not sure if I will extend it down the radiator as one piece or have it two piece. I was going to use expanded polystyrene but its just too messy to sand down, it gets everywhere and er'indoors wouldn't be too happy so foam board and a razor/hot glue gun is all I can really use at the mo. Final shaping will be with body filler and sanding .... outside (apparently).
Started to make a pattern for some winglets/side panels that I am tentatively planning on making from carbon fiber at some point...
Just trying to get a basic shape really but here is the fruits of an hours labour while ducking in the house to check on the little 'un.
I am liking the shape so far, I wasn't after totally flat wings, not sure if I will extend it down the radiator as one piece or have it two piece. I was going to use expanded polystyrene but its just too messy to sand down, it gets everywhere and er'indoors wouldn't be too happy so foam board and a razor/hot glue gun is all I can really use at the mo. Final shaping will be with body filler and sanding .... outside (apparently).
Intentionally left blank