28-08-15, 06:23 PM
(This post was last modified: 28-08-15, 06:44 PM by HarryHornby.)
UPDATE.....
I think I know why the washer is pushing in the metal (the gap where the axle runs through the swing arm) the washer on the brake side is saucer shaped, so when I tighten it it's not totally flat against the swing arm. It needs a new one. Does anyone have one?
So, removing the rear axle...... is it as simple as removing brake caliper then banging the axle all the way through and out the other side while catching the falling wheel? That's how it looks in Haynes.
Cheers
I think I know why the washer is pushing in the metal (the gap where the axle runs through the swing arm) the washer on the brake side is saucer shaped, so when I tighten it it's not totally flat against the swing arm. It needs a new one. Does anyone have one?
So, removing the rear axle...... is it as simple as removing brake caliper then banging the axle all the way through and out the other side while catching the falling wheel? That's how it looks in Haynes.
Cheers
Money doesn't buy happiness, but it buys beer, and that helps!