26-04-15, 06:41 PM
Luke spoke to mike on friday about this i have emailed brian g about sharing his drawing for us in the uk he will get back to me next week so if the drawing is any good i will pass it on if brian g cool about it, i want to use your fork exstenders waiting for my fz1 top yolk gen 2 was going to mate it to a 03 r1 bottom end both run 25○ offset i have seen i in the states wiith no top hat bush under top yolk so thats what i'm hoping to mate up, i'm interested in a stem , has you say a mild steel stem probably the way to go , i'm going to get r1 stem out of yolk this week at work ,i will heat up bottom yolk then press out so to get measurements without streaching the hole to see what shrinkage is needed