Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[Resolved] [Technical] 'Soft' front brakes
#25
(24-11-14, 08:57 PM)helloindustries link Wrote: So; I cleaned my callipers/pads/pistons today.

Rear was all good, but the front right had one piston pop out, now my brakes are worse, and there still might be air trapped in the bridging line over the mudguard. Also discovered a leak on the double set of banjos on the right side.

Brakes work, but wouldn't like to have to use them in an emergency.

Back down to the garage in the morning for a proper look, new washers and some investigation.

Why are you bridging across the mudguard?  :eek The best method for the fazer is 2 lines from the master cylinder, one to each caliper.
Reply


Messages In This Thread
Re: [Technical] 'Soft' front brakes - by Tefer - 17-11-14, 10:17 PM
Re: [Technical] 'Soft' front brakes - by Tefer - 17-11-14, 11:13 PM
Re: [Technical] 'Soft' front brakes - by unfazed - 25-11-14, 12:50 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)