17-11-14, 03:41 PM
(This post was last modified: 25-11-14, 12:52 PM by helloindustries.)
Recently had a banjo fitting replaced due to a small leak. Brakes were bled, but now feel much less effective than before.
Granted; They were never at 100% as the rotors were bent before i got it. They were straightened out, which sorted as much deformation in the discs as possible, and the brakes were good enough.
All i can think of is that they might need re-bleeding.
Thoughts?
-
Resolved
Leak on right side due to worn washers.
Now replaced, re-bled at all points and back to where they were (which wasn't 100%, and wont be unless i buy new discs).
Granted; They were never at 100% as the rotors were bent before i got it. They were straightened out, which sorted as much deformation in the discs as possible, and the brakes were good enough.
All i can think of is that they might need re-bleeding.
Thoughts?
-
Resolved
Leak on right side due to worn washers.
Now replaced, re-bled at all points and back to where they were (which wasn't 100%, and wont be unless i buy new discs).