Vibration noise around the clocks area.

[b1k3rdude]

There are a few things that cause vibs in the general location -

• make sure the infill panels arent missing there little strips of rubber along the edge that touches the inside of the front fairing. (5lv2834e00)
  
• make sure the 2x rubber dampers that go under the outside edges of the clocks aren't missing (5LV2834610)
  
• if you have a non-std screen you can get vibs from where it touches the front fairng - I put some strips of single sided foam there, I cut the strips from a sheet i got from hobbycraft. (this can also be used for the edges of the infills if need be)
  
• make sure the rubber stop between the front subframe and front fairing isnt missing (18a2472400 )
  
• Once the bike has done a few miles the front sub-loom connector can vibrate against the fairing on the l/h side - I used a bit of the single sided foam on the fairing there.
  

If I press in the top of the clocks the vibration noise goes.

That will be the top end of the sub-loom, locate where is rattling agaisnt the headlight/fairing and apply some foam tape.