Fitted the new bearings tonight.......my drift was'nt going to work, not enough room to get it in there, so I prised the rollers out and removed the plastic roller carrier from both sides I then used a length of 22mm copper tubing to knock the outer bearing casing out.....worked a treat 
.......cleaned everything up and pressed the bearings in square with my hands just to get them started, I then used a sash cramp to push them all the way in, then using a scoket slightly smaller than the bearing for the last little bit
Dropped the spindle in and no play what so ever
.....will put it back on the bike tomorrow.
.......cleaned everything up and pressed the bearings in square with my hands just to get them started, I then used a sash cramp to push them all the way in, then using a scoket slightly smaller than the bearing for the last little bitDropped the spindle in and no play what so ever
.....will put it back on the bike tomorrow.
One, is never going to be enough.....