23-04-14, 09:06 PM
hi foccers I have just managed to fit my nitron shock to my 99 fzs but have found the bottom shock bolt just a bit to short with the thicker shock fittings on the nitron the mountings are about 2 mm thicker either side.
this means the nut cant fully get on the bolt.
any on else had this issue?? it will go on fully if I leave the washer off is this a good idea??
this means the nut cant fully get on the bolt.
any on else had this issue?? it will go on fully if I leave the washer off is this a good idea??