11-12-13, 06:24 PM
(11-12-13, 03:18 PM)Tmation link Wrote:I hope they fit, the website says metric coarse thread (they spelt coarse wrong BTW not a good sign), but a lot of Japanese stuff is metric fine thread.
The studs are M6 course thread so they will be O.K.
One thing I would advise checking is that the stud isn't protruding so far beyond the exhuast flange that the domed nut bottoms out before tightening on the flange. Should be o.k but worth checking.
To check. If you screw a bolt into the nut you will probably get about 6 turns, so as long as the exhaust is tight before then, e.g. 6 turns, it's o.k. If not tight then fit a washer (or two) to make up the distance.