I've left my bike for about 1 month, because was quite busy last time.
I've tried to run it today, so I've opened the fuel and switched ignition twice so pump could build up pressure.
I think that my mistake was that month ago bike ran about 1 minute without tank, so there was not so much fuel left in carbs.
Now before pump could build a pressure there was leak from 2 hoses coming out from carbs, so I think that float valve was opened all the time.
Since leak was not the only issue, because bike was not running good before I've took of carbs and going to do proper job again.
Last time I've used Wynns carb cleaner, but as you see that was not enough.
I think about buying ultrasonic cleaner, but my question is if I clean it with ultrasonic cleaner, rinse it, do I need to have a compressor to remove the water or I can just leave them opened for few hours/days and they will be fine? I can not afford right now to buy ultrasonic cleaner and compressor at once.
What ultrasonic cleaner do you recommend to buy?
I've tried to run it today, so I've opened the fuel and switched ignition twice so pump could build up pressure.
I think that my mistake was that month ago bike ran about 1 minute without tank, so there was not so much fuel left in carbs.
Now before pump could build a pressure there was leak from 2 hoses coming out from carbs, so I think that float valve was opened all the time.
Since leak was not the only issue, because bike was not running good before I've took of carbs and going to do proper job again.
Last time I've used Wynns carb cleaner, but as you see that was not enough.
I think about buying ultrasonic cleaner, but my question is if I clean it with ultrasonic cleaner, rinse it, do I need to have a compressor to remove the water or I can just leave them opened for few hours/days and they will be fine? I can not afford right now to buy ultrasonic cleaner and compressor at once.
What ultrasonic cleaner do you recommend to buy?