26-10-13, 06:43 PM
(26-10-13, 06:29 PM)69oldskool link Wrote: So my advice to anyone yet to install would be to go with the larger holes than the 8mm ones i went with.
I forgot to say, I took my emus out and had a good look at them, all that blah I did about matching the size of the holes in the damper rod to the are of the 3 oval holes is a bit moot as it's actually the hole up the middle, under the plate the little spring holds down that really matters. Course I didn't measure it but it was probably around 12mm diameter minus the bolt so much smaller. Then again I dropped out of uni way before getting stuck in to fluid dynamics so I may just shut up on the subject now. I'm definitely not taking those damper rods out again anyway :rollin
Cheers,
Rob