Installation thread for Debrix fork cartridge emulators - Group buyers

[Dead Eye]

I now know what jams & why~,now freed up, just got to work out how i'm gona get the bush & oil seal back in without a suitable driver. :o

You can make your own driver for the cost of about £3-5

Get some PVC waste pipe about the same size as the fork leg and some jubilee clips. Cut two lengths of the PVC pipe and then cut them length ways on one side. Put one over the the fork inner (stanchion) towards the bottom (but leave some travel), then the other over the first piece (best to have the slits on opposite sides to each other). Ensure that he outer piece of pipe is slightly lower (5-10mm) than the inner one and then use the jubilee clip to clamp them to the fork inner. You can now use this as a driver for the seals

If my explanation is a load of crap then check out the video (skip to 15:50) created by Delboy's Garage as he explains it and shows you want to do I just used jubilee clips instead of the thing that he uses

http://www.youtube.com/watch?feature=pla...GX30#t=950