03-10-13, 09:05 PM
1. The brass pipes on the inlet rubbers are 5mm o/d with a raised swaging near the end that is 6mm dia.
2. My dial type vacuum gauges have adjustable restrictor valves attached with a short length of rubber tubing. (To dampen down the needle fluctuations).
3. The screws are not easy to see at first and you need the tank out of the way. A small dia. cross head screw driver which is fairly long, about 15cm at a guess, is required.
Hope that helps.
2. My dial type vacuum gauges have adjustable restrictor valves attached with a short length of rubber tubing. (To dampen down the needle fluctuations).
3. The screws are not easy to see at first and you need the tank out of the way. A small dia. cross head screw driver which is fairly long, about 15cm at a guess, is required.
Hope that helps.