03-10-13, 08:03 PM
Hi,
I've got 4 gauges, but with 6mm (inlet diameter) hose, also my gauges fit into 6mm hoses (but I think that 4mm with some heating would also fit)
It worked well with SV650, but it seems that I need 4mm hoses to fit into carburetor?
Also I could not find any air valves for 6mm so I've used just needle caps, but there is no way to change air flow... ;(.
1. Can you confirm inlet/outlet diameter of hoses?
2. What do you use as air vales?
3. I could not easily find screws where I can change throttle position, on service manual it's clear on the top of carburetor, but even If I lift my tank I could not properly see it.
What tool/screwdriver do you use to fit the screw?
I've got 4 gauges, but with 6mm (inlet diameter) hose, also my gauges fit into 6mm hoses (but I think that 4mm with some heating would also fit)
It worked well with SV650, but it seems that I need 4mm hoses to fit into carburetor?
Also I could not find any air valves for 6mm so I've used just needle caps, but there is no way to change air flow... ;(.
1. Can you confirm inlet/outlet diameter of hoses?
2. What do you use as air vales?
3. I could not easily find screws where I can change throttle position, on service manual it's clear on the top of carburetor, but even If I lift my tank I could not properly see it.
What tool/screwdriver do you use to fit the screw?