14-07-13, 03:23 PM
Just checked mine after reading this thread and it's not good news, the 9mm nut was loose and only being held on by the tab washer.
I tried to tighten it up again but it won't (i.e. it will thread along the shaft fine but it won't fully tighten up at the end)
Looks like the thread on the nut is worn and thankfully not the thread on the output shaft.
Asides from ordering the new bigger nut is there anything else I can do with this in the short term as a temporary fix?
I tried to tighten it up again but it won't (i.e. it will thread along the shaft fine but it won't fully tighten up at the end)
Looks like the thread on the nut is worn and thankfully not the thread on the output shaft.
Asides from ordering the new bigger nut is there anything else I can do with this in the short term as a temporary fix?