08-06-13, 07:46 AM
make sure you have completely cleaned the exhaust port where the copper gaskets sit, I held my new copper gaskets in will a little exhaust paste,
a little bit of fiddling and the pipes lined up, the only issue I had was the where the exhaust went under the engine the centre stand fouled them when being raised and lowered, I ground a little bit (1-2 mm off the stand where it rubbed, job done
a little bit of fiddling and the pipes lined up, the only issue I had was the where the exhaust went under the engine the centre stand fouled them when being raised and lowered, I ground a little bit (1-2 mm off the stand where it rubbed, job done