Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem at high revs
#9
Remove the the rubber plugs on the vacuum take off points and check them for cracks, they perish and crack and may need replacing.
Other issue may be loose plug caps, remove the caps and cut about 10mm of the end of the leads and refit the caps.
Reply


Messages In This Thread
Problem at high revs - by bignoggin - 29-04-13, 10:51 AM
Re: Problem at high revs - by Dead Eye - 29-04-13, 11:58 AM
Re: Problem at high revs - by darrsi - 29-04-13, 12:20 PM
Re: Problem at high revs - by Gnasher - 29-04-13, 12:24 PM
Re: Problem at high revs - by red98 - 29-04-13, 12:25 PM
Re: Problem at high revs - by bignoggin - 29-04-13, 01:19 PM
Re: Problem at high revs - by darrsi - 29-04-13, 01:30 PM
Re: Problem at high revs - by Gnasher - 29-04-13, 02:54 PM
Re: Problem at high revs - by unfazed - 30-04-13, 12:44 AM
Re: Problem at high revs - by darrsi - 30-04-13, 01:20 AM
Re: Problem at high revs - by bignoggin - 30-04-13, 11:44 PM
Re: Problem at high revs - by unfazed - 01-05-13, 12:22 AM
Re: Problem at high revs - by darrsi - 01-05-13, 06:45 AM
Re: Problem at high revs - by red98 - 08-05-13, 04:51 PM
Re: Problem at high revs - by bignoggin - 03-06-13, 10:50 AM
Re: Problem at high revs - by red98 - 03-06-13, 11:38 AM
Re: Problem at high revs - by ade the blade - 03-06-13, 12:27 PM
Re: Problem at high revs - by red98 - 03-06-13, 01:07 PM
Re: Problem at high revs - by bignoggin - 13-06-13, 04:35 PM
Re: Problem at high revs - by darrsi - 13-06-13, 04:49 PM
Re: Problem at high revs - by Fazerider - 13-06-13, 06:44 PM
Re: Problem at high revs - by Slaninar - 13-06-13, 06:53 PM
Re: Problem at high revs - by red98 - 13-06-13, 08:04 PM
Re: Problem at high revs - by Gnasher - 13-06-13, 09:36 PM
Re: Problem at high revs - by bignoggin - 13-06-13, 10:02 PM
Re: Problem at high revs - by littlejohno - 14-06-13, 07:13 PM
Re: Problem at high revs - by Dead Eye - 14-06-13, 10:21 PM
Re: Problem at high revs - by littlejohno - 14-06-13, 10:59 PM

Forum Jump:


Users browsing this thread: