26-04-13, 12:39 PM
Assuming it's the same as the earlier version, it is just a plain steel hole.
I added a steel washer to the shaft to cut down on the free play where the lever (and wafer thin spring washer) wears against the alloy hanger and also a rubber 'O' ring to try to keep rain/grit out and grease in. It's helped, but has now done about 80k so the lever and pivot could do with being replaced again.
I added a steel washer to the shaft to cut down on the free play where the lever (and wafer thin spring washer) wears against the alloy hanger and also a rubber 'O' ring to try to keep rain/grit out and grease in. It's helped, but has now done about 80k so the lever and pivot could do with being replaced again.