13-04-13, 10:29 AM
Mornin all,Ive just been trying to fit my simmi end can but the link pipe doesnt want to go on as far as the original was.
The link pipe has 3 slots cut outta it for expanding but it only goes on as far as the end of the slots (which makes sense),about an inch instead of going flush up the end of the tapered part of the downpipe like the original,im guessing this is normal,i cant push it on any further & it wont twist on any further but it doesnt seem like allot of a join & its annoying it doesnt go up to the end of the down pipe,plus the sticky out triangular piece on the link pipe (guessing is a stop for the centre stand or somethin) is quite close to the rear brake torque arm.
Anyone got any suggestions please?
The link pipe has 3 slots cut outta it for expanding but it only goes on as far as the end of the slots (which makes sense),about an inch instead of going flush up the end of the tapered part of the downpipe like the original,im guessing this is normal,i cant push it on any further & it wont twist on any further but it doesnt seem like allot of a join & its annoying it doesnt go up to the end of the down pipe,plus the sticky out triangular piece on the link pipe (guessing is a stop for the centre stand or somethin) is quite close to the rear brake torque arm.
Anyone got any suggestions please?
Easiest way to go fast........don't buy a blue bike